Milan L4-2.3L VIN Z (2006)
-
The fuel pump module must be handled carefully to avoid damage to the float arm.
-
Place absorbant pads on the floor pan in the immediate area in case of fuel spills. Carefully remove the fuel pump module from the vehicle to
avoid fuel spillage inside the vehicle.
-
The fuel pump module will have residual fuel remaining internally, drain into a suitable container.
Completely remove the fuel pump module from the fuel tank.
10. CAUTION:
-
Inspect the mating surfaces of the fuel pump module flange and the fuel tank O-ring seal contact surfaces. Do not polish or adjust the
O-ring seal contact area of the fuel tank flange or the fuel tank. Install a new fuel pump module or fuel tank if the O-ring seal contact
area is bent, scratched or corroded.
-
Make sure to install a new fuel pump module O-ring seal and lock ring.
NOTE: To install, apply clean engine oil to the O-ring seal.
Remove the fuel pump module O-ring seal.
11. To install, reverse the removal procedure.
-
Make sure the alignment tab on the fuel pump module and the fuel tank meet before tightening the fuel pump module lock ring.
