Milan L4-2.3L VIN Z (2006)
operation and does not indicate a supplemental restraint system SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
Passenger side shown, driver similar.
1. Depower the system.
2. Detach the side air bag module bolt cover.
3. NOTE: Note the position of the side air bag module locator hook in the side air bag module bracket (on the seat back frame) for installation.
Remove the bolt and lift up and out, to detach the side air bag module from the seat back.
-
To install, tighten to 10 Nm (89 lb-in).
4. Slide and disengage the side air bag module electrical connector locking clip, and then release the tab and disconnect the side air bag module
electrical connector.
5. WARNING:
-
Inspect the mounting surfaces of the side air bag module for any foreign objects before installing the side air bag module. If any
foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
-
If the air bag cover has separated or the air bag material has been exposed, install a new side air bag module. Do not attempt to repair
the air bag module. Failure to do so may result in personal injury in the event of an air bag deployment.
To install, reverse the removal procedure.
6. Repower the system.
