Milan L4-2.3L VIN Z (2006)
10. NOTE: Note the position of the side air curtain module center guide hook retainer for installation.
Remove the side air curtain module 2 center guide bolts. Detach the side air curtain module center guide hook retainer from the vehicle sheetmetal.
-
To install, tighten to 7 Nm (62 lb-in).
11. Remove the side air curtain module.
-
Move the side air curtain module toward the front of the vehicle to release the rear bracket hook from the C-pillar sheetmetal.
12. WARNING:
-
Before installing a side air curtain module, inspect the roof line for any damage. If necessary, the sheet metal must be reworked to its
original condition and structural integrity. All damaged fasteners must be replaced and any foreign objects removed. Failure to do so
may result in personal injury in the event of a side air curtain deployment.
-
Inspect the side air curtain before installation. If the side air curtain is damaged or the cover has separated and the curtain material
has been exposed, a new side air curtain module must be installed. Do not attempt to repair the side air curtain module. Failure to
follow these instructions can result in personal injury in the event of a side air curtain module deployment.
-
Never put any type of fastener or tie strap around any part of the side air curtain module or interior trim panel. This will prevent the
side air curtain module from deploying correctly. Failure to do so can result in personal injury in the event of a side air curtain
module deployment.
NOTE: Make sure all side air curtain module bolt holes line up with all the vehicles bolt holes.
To install, reverse the removal procedure.
13. Install the headliner.
14. Repower the system.
