Milan L4-2.3L VIN Z (2006)
2. If equipped, remove the wheel speed sensor bolt.
^
To install, tighten to 23 Nm (17 ft. lbs.).
3. If equipped, remove the wheel speed sensor harness bolt and position the wheel speed sensor aside.
^
To install, tighten to 23 Nm (17 ft. lbs.).
4. CAUTION: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the bolts and position the caliper and anchor plate assembly aside.
^
Support the caliper and anchor plate assembly using mechanic's wire.
^
To install, tighten to 90 Nm (66 ft. lbs.).
5. Remove the 2 brake disc bolts and remove the brake disc.
^
To install, tighten to 20 Nm (15 ft. lbs.).
6. Remove and discard the halfshaft nut.
^
To install, tighten to 255 Nm (189 ft. lbs.).
7. Using the special tool, separate the halfshaft from the wheel hub.
8. Remove and discard the upper ball joint nut.
^
To install, tighten to 48 Nm (35 ft. lbs.).
