Milan L4-2.3L VIN Z (2006)
Using the special tool, separate the 2 tie-rod ends from both wheel knuckles.
12. Remove RH steering gear-to-subframe bolt.
^
To install, tighten to 107 Nm (79 ft. lbs.).
13. Remove the 2 LH steering gear-to-subframe bolts and position the steering gear to access the stabilizer bar LH bracket front nut.
^
To install, tighten to 107 Nm (79 ft. lbs.).
14. Remove and discard the 4 stabilizer bar bracket nuts and remove the 2 stabilizer bar brackets.
^
To install, tighten the bracket nuts to 48 Nm (35 ft. lbs.) with the suspension at the bushing fastener tightening position.
15. Remove the 2 stabilizer bar bushings.
16. CAUTION: Before tightening the stabilizer bar bracket nuts, the suspension must be at the bushing fastener tightening position. Use a suitable
jack to raise the suspension until the distance between the center of the hub and the lip of the fender is equal to 402 mm (15.83 inch).
CAUTION: A new bolt and new seals must be installed any time the power steering pressure line is disconnected from the power steering gear.
