Milan L4-2.3L VIN Z (2006)
NOTE: Once pressure is applied to the ball joint with the special tool, it may be necessary to tap the wheel knuckle at the ball joint area to
separate the ball joint from the wheel knuckle.
Using the special tools, separate the RH and LH ball joints.
16. Remove the lower control arm-to-strut through bolts and flagnuts.
-
To install, tighten to 103 Nm (76 lb-ft).
17. Position the lift table under the subframe.
18. Remove the 2 rear mounting nuts and washers from the front subframe.
-
To install, tighten to 150 Nm (111 lb-ft).
19. Remove the 4 bolts and the 2 subframe support brackets.
-
To install, tighten to 103 Nm (76 lb-ft).
