Milan L4-2.3L VIN Z (2006)
Suspension Spring ( Coil / Leaf ): Service and Repair
Front
Removal and Installation
Shock Absorber and Spring Assembly
Shock Absorber and Spring Assembly
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in major
service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement part of lesser
quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
1. Remove and discard the 3 shock absorber upper mount nuts.
^
To install, tighten to 30 Nm (22 ft. lbs.).
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
