Milan L4-2.3L VIN Z (2006)
1. Position the spring upper seat onto the spring. The end of the spring should be 0 - 10 mm (0 - 0.39 inch) from the step on the seat.
2. If removed, position the spring lower seat into the lower arm aligning the recess in the seat with the projection on the lower arm.
3. Position the spring onto the lower arm with the end of the spring 0 - 10 mm (0 - 0.39 inch) from the step on the spring seat.
4. NOTE: Do not tighten the bolt at this time.
Using a suitable jack, raise the lower arm and install the lower arm outboard bolt.
5. CAUTION: Before tightening any suspension bushing fasteners, the suspension must be at the bushing fastener tightening position.
Using a suitable jack, raise the suspension until the distance between the center of the hub and the lip of the fender is equal to 395 mm (15.55
inch).
6. Tighten the lower arm outboard bolt to 101 Nm (74 ft. lbs.).
