Milan L4-2.3L VIN Z (2006)
Using a suitable dent puller, remove the differential fluid seal.
Installation
1. Position the new differential fluid seal on the special tool.
2. Using the special tool, install the outer differential fluid seal.
3. Install the RH halfshaft.
4. With the transaxle in (P) PARK, the vehicle on a level surface, the engine at idle (680 - 780 rpm) and foot pressed on the brake, move the selector
lever through each gear and allow engagement of each gear. Place the selector lever back in the PARK position.
5. Wipe the fluid level indicator cap and remove the fluid level indicator.
6. Wipe the fluid level indicator with a clean cloth.
7. NOTE: In order to get an accurate fluid level reading, the vehicle should be on a level surface. Idle the engine to reach the normal operating
temperature. Using the WDS, verify that the transaxle is at normal operating temperature 60°C - 70°C (140°F - 158°F), prior to adjusting the
transmission fluid level.
