Milan AWD L4-2.3L (2008)
Install the 2 head restraint guides through the backrest trim cover and into the backrest frame.
3. Position the hard back panel and install the pin-type retainers.
4. Roll the backrest trim cover down and install hog rings attaching the backrest trim cover to the backrest foam pad in front and the backrest frame
wire in the rear.
-
Feed the side air bag wire harness through the side of the backrest trim cover.
-
If equipped with heat, feed the wire harness through the side of the backrest trim cover.
5. Attach the hook-and-loop strips at the bottom of the backrest trim cover.
6. Attach the inner and outer backrest trim cover lower J-clips.
7. Install the head restraint.
8. WARNING:
-
If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed, install a
new seat side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in the
seat side air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
-
Inspect the seat side air bag module and mounting surfaces for any damage or foreign material before installing the seat side air bag
module. If any damage is found, install new components. If any foreign material is found, remove it. Failure to follow these
instructions may result in the seat side air bag module deploying incorrectly and increase the risk of serious personal injury or death
in a crash.
Connect the side air bag module electrical connector, then slide and engage the side air bag electrical connector locking clip.
9. Install the side air bag module to the mounting bracket on the backrest frame.
-
Position the side air bag module locator hook in the side air bag bracket.
10. Align the bolt hole and install the side air bag bolt.
-
Tighten to 10 Nm (89 lb-in).
11. Install the side air bag bolt cover.
12. Position the backrest assembly and install the 4 recliner-to-backrest frame bolts.
-
Tighten to 55 Nm (41 lb-ft).
13. Route the side air bag wire harness down the side of the seat and through the cushion frame hole.
14. Route and attach the side air bag wire harness.
15. Connect the heated seat and side air bag electrical connectors.
-
If equipped, connect the heated seat electrical connector, route the wire harness and attach any pin-type retainers.
