Milan AWD L4-2.3L (2008)
22. NOTE: Discard the TB gasket.
Remove the 4 bolts and position the TB aside.
^
To install, tighten to 10 Nm (89 lb-inch).
23. Detach the 2 pin-type retainers from the intake manifold.
24. NOTE: There are 2 different size bolts used. Mark the location of the bolts to make sure they are installed in their original locations.
Remove the 7 bolts and position the intake manifold aside to access the crankcase vent hose clamp and the EGR tube.
^
To install, tighten to 18 Nm (13 lb-ft).
25. Release the clamp and disconnect the crankcase vent hose.
26. Detach the knock sensor (KS) electrical connector pin-type retainer.
27. Remove the EGR tube.
^
To install, tighten to 55 Nm (41 lb-ft).
28. Remove the intake manifold and discard the gaskets.
^
To install, tighten to 18 Nm (13 lb-ft).
29. To install, reverse the removal procedure.
^
Install new TB and intake manifold gaskets.
