Milan AWD L4-2.3L (2008)
10. Install a suitable lifting device under the fuel tank.
11. Remove the 4 bolts and the fuel tank straps.
-
To install, tighten to 40 Nm (30 lb-ft).
12. Partially lower the fuel tank enough to access the fuel tank filler pipe hose clamp.
13. NOTE: Some residual fuel may remain in the fuel tank filler pipe. When removing the filler pipe, carefully drain the fuel into a suitable container.
Release the clamp and disconnect the fuel tank filler pipe hose from the fuel tank
-
To install, tighten to 4 Nm (35 lb-in).
14. Disconnect the fuel vapor tube assembly-to-fuel tank quick connect coupling.
15. Remove the fuel vapor tube assembly.
16. To install, reverse the removal procedure.
-
Carry out an Evaporative Emission System Leak Test. See: Testing and Inspection
-
Carry out the EVAP repair verification drive cycle.
