Milan AWD L4-2.3L (2008)
6. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
NOTE:
-
Make sure the B-pillar and side impact sensor mating surfaces are clean and free of foreign material.
-
Note position of the sensor and locating tab for installation.
Remove the bolt and side impact sensor.
-
To install, tighten to 12 Nm (9 lb-ft).
7. To install, reverse the removal procedure.
8. Repower the SRS.