Milan AWD L4-2.3L (2008)
3. Release the clamp and disconnect the power steering return hose from the power steering fluid reservoir.
4. Disconnect the power steering pressure switch electrical connector.
5. Remove the pressure line-to-power steering pump banjo bolt and disconnect the line from the power steering pump.
^
Discard the bolt and 2 seals.
^
To install, tighten to 48 Nm (35 lb-ft).
6. Remove the 3 power steering pump bolts and the power steering pump.
^
To install, tighten to 24 Nm (18 lb-ft).
7. CAUTION: A new bolt and new seals must be installed any time the power steering pressure line is disconnected from the power steering
pump or a fluid leak may occur.
To install, reverse the removal procedure.
8. Fill the power steering system.
