Milan AWD L4-2.3L (2008)
12. NOTE: RH side shown, LH side similar.
Remove the 6 pin-type retainers (4 shown) from the LH and RH splash shield.
13. If equipped, remove the bolts and the underbody splash shield.
14. Remove the 2 outer tie-rod end cotter pins and nuts.
^
Discard the cotter pins.
15. CAUTION: Do not use a hammer to separate the outer tie-rod end from the wheel knuckle or damage to the wheel knuckle may result.
Using the special tool, separate the outer tie-rod ends from the knuckle.
16. NOTE: Always install new fasteners and gaskets. Clean flange faces prior to new gasket installation to make sure of proper sealing.
Remove and discard the 2 catalytic converter-to-exhaust flexible pipe nuts and separate the exhaust flexible pipe.
