Milan AWD L4-2.3L (2008)
All vehicles
14. Remove RH steering gear-to-subframe bolt.
^
To install, tighten to 107 Nm (79 lb-ft).
15. Remove the 2 LH steering gear-to-subframe bolts and position the steering gear to access the stabilizer bar LH bracket front nut.
^
To install, tighten to 107 Nm (79 lb-ft).
16. Remove and discard the 4 stabilizer bar bracket nuts and remove the 2 stabilizer bar brackets.
^
To install, tighten the bracket nuts to 48 Nm (35 lb-ft).
17. Remove the 2 stabilizer bar bushings.
18. CAUTION: Before tightening the stabilizer bar bracket nuts, the suspension must be at the bushing fastener tightening position. Use a
suitable jack to raise the suspension until the distance between the center of the hub and the lip of the fender is equal to 402 mm (15.83
in). This will prevent incorrect clamp load and bushing damage.
To install, reverse the removal procedure.
