Milan FWD L4-2.3L (2008)
^
Ensure the microphone is parallel and adjacent to overhead console trim.
2. Lower the overhead console. Refer to WSM, Section 501-12 for additional information.
3. Route microphone cable up through existing hole in the headliner and over to the driver side A-pillar. It may be necessary to slightly drop headliner
to run microphone cable. Refer to WSM, Section 501-05 for additional information.
4. Install overhead console; ensure microphone cable enters the overhead console trim directly behind microphone as shown.
5. Gain access to connectors 210 and 211 in the left A-pillar. Refer to online WD, Section 124 for links to location and connector views.
6. Identify circuits VMM13, RMM13 and DMM13 (shield) from C211. Cut the three circuits on the female side of the connector (14334 harness).
These are the microphone positive, negative and shield circuits. Then splice the yellow jumper harness wire to VMM13 and any two of the three
black jumper harness wires to RMM13 and DMM13 (shield). Only splice into the cut wires heading in the direction of the connector. Tape off and
secure the cut wire ends heading up the A-pillar as they are no longer used.
7. Identify circuits CBP41 and GD133 from C210. This is power and ground for both the new microphone and the existing mirror. Splice in the blue
jumper harness wire to CBP41 and the remaining black jumper harness wire to GD133. Ensure that the original circuits remain intact and connected
as this is power for other items within the rear view mirror and in the roof.
8. Do not plug in the microphone at this time, proceed to Final Test / Service Steps.
Escape / Mariner
1. Remove the protective backing from the adhesive on the microphone and attach the microphone as shown in the illustration (Figures 2 and 3). Firmly
press the microphone into place. Ensure the microphone is parallel and adjacent to overhead console trim (if equipped) or positioned directly above
A-pillar on headliner if not equipped with an overhead console. Proceed to Step 5 if not equipped with an overhead console.
2. Lower the overhead console. Refer to WSM, Section 417-02 for additional information.
3. Route microphone cable through existing hole in the headliner and over to the driver side A-pillar. It may be necessary to slightly drop headliner to
run microphone cable.
4. Install overhead console; ensure microphone cable enters the overhead console trim directly behind microphone as shown.
