Milan FWD L4-2.3L (2008)
^
Firmly press the microphone into place.
^
Ensure the microphone is parallel and adjacent to overhead console trim.
2. Lower the overhead console. Refer to WSM, Section 501-12 for additional information.
3. Route microphone cable through existing hole in the headliner and over to the driver side A-pillar. It may be necessary to slightly drop headliner to
run microphone cable. Refer to WSM, Section 501-05 for additional information.
4. Install overhead console; ensure microphone cable enters the overhead console trim directly behind microphone as shown.
5. Gain access to connector 248 in the left A-pillar. Refer to online WD, Section 124 for links to location and connector views.
6. Identify circuits VMNO7, RMNO7 and DMNO7 (shield) from C248 (Sport Trac uses C260). Cut the three circuits on the female side of the
connector (14334 harness). These are the microphone positive, negative and shield circuits. Then splice the yellow jumper harness wire to VMNO7
and any two (of the three) black jumper harness wires to RMNO7 and DMNO7 (shield). Only splice into the cut wires heading in the direction of the
connector. Tape off and secure the cut wire ends heading up the A-pillar as they are no longer used.
7. Identify circuits CBPO5 and GD143 from C248. This is power and ground for both the new microphone and the existing mirror. Splice in the blue
jumper harness wire to CBPO5 and the remaining black jumper harness wire to GD143. Ensure that the original circuits remain intact and connected
as this is power for other items within the rear view mirror and in the roof.
8. Do not plug in the microphone at this time, proceed to Final Test / Service Steps.
F-150
1. Remove the protective backing from the adhesive on the microphone and attach the microphone. (Figure 7)
^
Firmly press the microphone into place.
^
Ensure the microphone is parallel and adjacent to overhead console trim or front lamp.
2. Lower the overhead console or front lamp. Refer to WSM, Section 501-12 for additional information.
3. Route microphone cable through existing hole in the headliner and temporarily tuck excess wire into headliner to the rear of the console or lamp.
4. Install overhead console or front lamp; ensure microphone cable enters the overhead console or front lamp trim directly behind microphone as
shown.
5. Gain access to connectors 314 and 315 in roof panel near left hand side. Refer to online WD, Section 124 for links to location and connector views.
6. Identify circuits VMM13, RMM13 and DMM13 (shield) from C314. Cut the three circuits on the female side of the connector (14358 harness).
These are the microphone positive, negative and shield circuits. Then splice the yellow jumper harness wire to VMM13 and any two (of the three)
black jumper harness wires to RMM13 and DMM13 (shield). Only splice into the cut wires heading in the direction of the connector. Tape off and
secure the cut wire ends heading up the A-pillar as they are no longer used.
7. Identify circuits CBP41 from C315 and GD133 from C314. This is power and ground for both the new microphone and the existing mirror. Splice in
the blue jumper harness wire to CBP41 and the remaining black jumper harness wire to GD133. Ensure that the original circuits remain intact and
connected as this is power for other items within the rear view mirror and in the roof.
