Milan FWD L4-2.3L (2008)
1. Remove the protective backing from the adhesive on the microphone and attach the microphone. (Figure 7)
^
Firmly press the microphone into place.
^
Ensure the microphone is parallel and adjacent to overhead console trim or front lamp.
2. Lower the overhead console or front lamp. Refer to WSM, Section 417-02 for additional information.
3. Route microphone cable through existing hole in the headliner, and temporarily tuck excess wire into headliner to the rear of the console or lamp.
4. Install overhead console or front lamp; ensure microphone cable enters the overhead console or front lamp trim directly behind microphone as
shown.
5. Gain access to connectors 314 and 315 in roof panel near left hand side. Refer to online WD, Section 124-1 for links to location and connector
views.
6. Identify circuits VMM13 (YE-GN), RMM13 (BU), and DMM13 (shield) from C314. Cut the three circuits on the female side of the connector
(14358 harness).
7. Identify circuits CBP41 (BU) from C315 and GD133 (BK) from C314.
8. Splice the five jumper harness wires into the following circuits:
^
Blue jumper harness wire to CBP41 (BU) and any black jumper harness wire to GD133 (BK).
^
Ensure original circuits remain connected in splice.
^
Yellow jumper harness wire to VMM13 (YE-GN) and remaining black jumper harness wires to RMM13 (BU) and DMM13 (shield).
^
Only splice into the cut wires heading in the direction of the connector. Tape off and secure the other cut wire ends as they are no longer used.
9. Attach the microphone connector to the jumper harness connector.
10. Bundle and tuck the remainder of the microphone cable above the headliner.
2009 F-Super Duty
