Milan FWD L4-2.3L (2008)
10. Connect the passenger seat side air bag module electrical connector and then slide and engage the seat side air bag electrical connector locking
clip.
11. CAUTION:
-
Do not install the passenger air bag module electrical connectors by the locking buttons. Damage to the locking buttons can occur.
-
The passenger air bag module electrical connector locking buttons must be in the released position when the connector is being
installed, or connector damage may occur.
-
The passenger air bag module electrical connectors are unique and cannot be reversed when connected to the passenger air bag
module. Match the electrical connector key to the keyway in the passenger air bag module. Do not force the electrical connectors into
the passenger air bag module.
NOTE: RH shown, LH similar.
With the locking buttons released, install the passenger air bag module electrical connectors fully into the passenger air bag module and seat the
locking buttons.
MKZ
12. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment door. Damage to the passenger air bag
module may occur.
NOTE: During air bag module installation, make sure all the deployment door clips are fully seated in the instrument panel.
Install the passenger air bag module into the instrument panel.
13. Through the glove compartment opening, install the 2 passenger air bag module bolts.
-
Tighten to 8 Nm (71 lb-in).
