Milan FWD L4-2.3L (2008)
-
Tighten to 6 Nm (53 lb-in).
Seat with power recliner
3. NOTE: The recliners are synchronized. Avoid rotating the recliner shaft until fully installed.
Install the recliner motor.
1
Position the recliner shaft through the recliner motor and RH recliner.
2
Install a new one-way push clip onto the recliner shaft at the RH recliner.
3
Slightly turn the recliner motor to align the bolt hole with the hole in the RH recliner and install the recliner motor bolt.
-
Tighten to 6 Nm (53 lb-in).
4
Connect the recliner motor electrical connector.
Climate controlled seat
4. CAUTION: Before assembly, inspect the climate controlled seat components for damage, crush, obstruction and foreign material and
repair as needed.
Install the upper support spring and TED assembly to the backrest frame.
-
Attach the TED and bracket to the backrest upper support spring as noted in disassembly, if removed.
5. Connect the exhaust duct to the TED and install a new tie strap.
6. Connect the TED electrical connector.
All seats
7. Attach the lumbar assembly spring clips and install the lumbar assembly to the backrest frame.
-
Route the lumbar cable to the backrest as in disassembly, if equipped.
-
Connect the power lumbar motor electrical connector, if equipped.
8. Install the side air bag wiring harness.
-
Route the side air bag wiring harness to the backrest frame as noted in disassembly and install the pushpin-type retainers.
9. Position the backrest foam pad to the backrest frame.
-
If removed, install a new backrest heater mat.
-
For installation, peel away the paper from the adhesive strips, align and apply the new heater mat to the backrest foam pad being sure to
tuck the heater mat into the foam pad creases.
-
The heater mat must lay flat on the foam pad with no wrinkles.
Climate controlled seat
10. CAUTION: Before assembly, inspect the climate controlled seat components for damage, crush, obstruction and foreign material and
repair as needed.
If removed, align the backrest manifold and insert into the valleys of the foam pad.
-
Check for correct fit between the manifold, foam pad and TED assembly, to make sure there is no air flow obstruction or cushion crush.
11. Install new hog rings to the upper support spring and foam pad.
