Milan FWD L4-2.3L (2008)
All seats
12. NOTE: A backrest trim cover for a seat with a side air bag module is different than a backrest trim cover for a seat without a side air bag module.
Make sure the correct backrest trim cover is being installed.
Position the backrest trim cover to the backrest frame and foam pad and install new rear upper hog rings to the backrest frame.
13. Roll the backrest trim cover downward and attach the hook-and-loop strips.
-
If removed, install new hog rings as noted during disassembly.
14. NOTE: The head restraint guides are keyed to the backrest frame and are not interchangeable.
Install the 2 head restraint guides to the backrest.
15. Connect the inner and outer backrest trim cover J-strips.
16. Install the 2 pin-type retainers and trim cover flaps to the recliners, if equipped.
17. WARNING:
-
If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed, install a
new seat side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in the
seat side air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
-
Inspect the seat side air bag module and mounting surfaces for any damage or foreign material before installing the seat side air bag
module. If any damage is found, install new components. If any foreign material is found, remove it. Failure to follow these
instructions may result in the seat side air bag module deploying incorrectly and increase the risk of serious personal injury or death
in a crash.
Connect the side air bag module electrical connector and then slide and engage the side air bag electrical connector locking clip.
18. Install the side air bag module to the mounting bracket on the backrest frame.
-
Position the side air bag module locator hook in the side air bag bracket the seat back frame.
19. Align the bolt hole and install the side air bag bolt.
-
Tighten to 10 Nm (89 lb-in).
20. Install the side air bag bolt cover.
21. Install the front seat backrest.
22. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
23. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test.
