mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Seat Backrest Cover - Front|Page 7310 > < Seat Backrest Cover - Front|Page 7308
Page 9
background image

4. NOTE:  Note the position of the side air bag module locator hook in the side air bag module bracket (on the seat back frame) for installation.

Remove the bolt and lift up and out to detach the side air bag module from the seat backrest.
-

To install, tighten to 10 Nm (89 lb-in).

5. Slide and disengage the side air bag module electrical connector locking clip, and then release the tab and disconnect the side air bag module

electrical connector and remove the side air bag module.

6. Detach the 2 pin-type retainers and trim cover flaps from the recliners.

7. CAUTION:  Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from

the backrest foam pad.

Release the outer and inner backrest trim cover lower J-clips and partially invert the trim cover to the hook-and-loop strips.

8. NOTE:  The head restraint guides are not interchangeable. Note location for installation.

Reach up into the backrest and squeeze the head restraint guide ends together to release. Pull the 2 head restraint guides out of the backrest frame.

9. Remove all rows of hog rings from the backrest trim cover and separate the hook-and-loop strips while inverting the trim cover up the backrest.

10. Remove the rear upper hog rings and backrest trim cover.

-

To install, make sure the climate controlled seat backrest manifold is correctly aligned to the foam pad, if equipped.

11. WARNING:

-

If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed, install a
new seat side air bag module. Never try to repair the seat side air bag module. Failure to follow these instructions may result in the
seat side air bag deploying incorrectly, which increases the risk of serious personal injury or death in a crash.

-

Inspect the seat side air bag module and mounting surfaces for any damage or foreign material before installing the seat side air bag
module. If any damage is found, install new components. If any foreign material is found, remove it. Failure to follow these

Seat Backrest Cover - Front|Page 7310 > < Seat Backrest Cover - Front|Page 7308