Milan FWD L4-2.3L (2008)
-
To install, tighten to 10 Nm (89 lb-in).
6. Separate the armrest assembly from the backrest and position aside.
-
For assembly, align the armrest bracket locator tab to the backrest frame.
7. Release the 4 pin-type retainers, separate the armrest trim cover panel from the backrest and remove the armrest assembly.
-
For a broken retainer, push the remaining end through and into the backrest frame and install a new pin-type retainer during assembly.
8. Remove the pin-type retainer from the backrest trim cover armrest pocket.
All seats
9. Release the 4 lower trim cover J-clips at both sides of the backrest and remove the staples.
10. CAUTION: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from
the backrest foam pad.
Continue to invert the backrest trim cover separating the hook-and-loop strips and removing all rows of hog rings working up the backrest.
11. Remove the backrest trim cover.
12. To install, reverse the removal procedure.
13. Install the 60 percent rear seat backrest assembly.
14. Install the rear seat cushion.
