Milan FWD L4-2.3L (2008)
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Disconnect the battery ground cable.
2. Remove the degas bottle.
3. Disconnect the ABS module electrical connector.
4. Disconnect the brake tube fittings.
^
To install, tighten to 17 Nm (13 lb-ft).
5. Remove the hydraulic control unit (HCU) bracket-to-frame nut.
^
To install, tighten to 23 Nm (17 lb-ft).
6. NOTE: If installing a new bolt, use only the Torx(R) head type for vehicles equipped with a 3.5L engine.
Remove the HCU bracket-to-frame bolt.
^
To install, tighten to 23 Nm (17 lb-ft).
7. Remove the HCU bracket-to-frame stud.
^
To install, tighten to 23 Nm (17 lb-ft).
8. Remove the HCU and bracket.
9. Remove the HCU bracket-to-HCU bolt and remove the bracket.
^
To install, tighten to 9 Nm (80 lb-inch).
10. NOTE: Make sure the HCU and ABS module are clean and free of any brake fluid or foreign material before separating the components.
