Milan FWD L4-2.3L (2008)
Removal
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Remove the wheel and tire.
2. Disconnect the parking brake cable from the brake caliper.
^
Pull back the parking brake lever.
^
Disconnect the cable from the parking brake lever.
^
Remove the cable conduit retaining clip.
^
Disconnect the cable from the brake caliper.
3. Remove the brake caliper flow bolt and position the brake hose aside.
^
Discard the 2 copper washers.
4. Remove the 2 brake caliper guide pin bolts and the brake caliper.
^
If a leaking or damaged caliper piston boot is found, install a new disc brake caliper.
Installation
1. Position the notch in the caliper piston so that it will correctly align with the pin on the backside of the inboard brake pad.
