Milan FWD L4-2.3L (2008)
3. Install the 2 brake pads, shims and slide clips to the brake caliper anchor plate.
4. NOTE: Make sure that the brake caliper hose is not twisted.
Position the brake caliper on the anchor plate and install the 2 bolts.
^
Tighten to 26 Nm (19 lb-ft).
5. Install the parking brake cable to the brake caliper.
^
Pull back the parking brake lever.
^
Connect the cable to the parking brake lever.
^
Install the cable conduit retaining clip.
6. Install the wheel and tire.
7. Fill the brake master cylinder reservoir with clean, specified brake fluid.
8. Cycle the park brake several times to verify normal operation.
^
Apply brakes several times to verify correct brake operation.
