Milan FWD L4-2.3L (2008)
Remove the 2 brake caliper anchor plate bolts and position the brake caliper, brake pads and brake caliper anchor plate aside as an assembly.
^
Support the brake caliper, brake pads and brake caliper anchor plate assembly using mechanic's wire.
4. Remove the 2 brake disc screws and the brake disc.
Installation
1. NOTE: Make sure the brake disc-to-hub mounting surface is free of rust and foreign material before applying anti-seize lubricant.
Install the brake disc and the 2 brake disc screws.
^
Tighten to 20 Nm (15 lb-ft).
2. NOTE: Make sure that the brake caliper hose is not twisted.
Position the brake caliper, brake pads and brake caliper anchor plate assembly and install the 2 brake caliper anchor plate bolts.
^
Tighten to 70 Nm (52 lb-ft).
3. Install the parking brake cable to the brake caliper.
^
Pull back the parking brake lever.
^
Connect the cable to the parking brake lever.
^
Install the cable conduit retaining clip.
4. Install the wheel and tire.
5. Cycle the park brake several times to verify normal operation.
^
Apply brakes several times to verify correct brake operation.
Shield Removal and Installation, Rear
Brake Disc Shield - Front Wheel Drive (FWD)
