Milan FWD L4-2.3L (2008)
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Disconnect the brake fluid level warning switch electrical connector.
2. Using a suitable suction device, remove the brake fluid from the brake master cylinder reservoir.
3. If equipped with a manual transmission, disconnect the clutch master cylinder feed hose.
^
Plug the clutch master cylinder feed hose.
4. Disconnect the brake tube fittings, plug the brake tubes and the brake master cylinder ports.
^
To install, tighten to 17 Nm (13 lb-ft).
5. Remove the 2 brake master cylinder nuts.
^
To install, tighten to 25 Nm (18 lb-ft).
6. Remove the brake master cylinder.
7. To install, reverse the removal procedure.
^
Bleed the master cylinder.
^
If equipped with a manual transmission, bleed the clutch master cylinder.
Brake Master Cylinder - 3.5L
Brake Master Cylinder - 3.5L
Material
NOTE: Automatic transmission shown, manual transmission similar.
