Milan FWD L4-2.3L (2008)
Thermostat Housing: Service and Repair
Thermostat Housing - 2.3L
NOTE: The thermostat and thermostat housing are serviced as an assembly.
Thermostat Housing - 2.3L
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Drain the cooling system.
3. Remove the 3 bolts and reposition the thermostat housing to gain access to the hose clamps.
^
Remove and discard the gasket.
^
To install, tighten the bolts to 10 Nm (89 lb-inch).
4. Disconnect the heater hose from the thermostat housing.
5. Disconnect the lower radiator hose from the thermostat housing and remove the thermostat housing.