Milan FWD L4-2.3L (2008)
Air Bag(s) Arming and Disarming: Service and Repair
Supplemental Restraint System (SRS) Depowering and Repowering
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING
Special Tool(s)
Special Tool(s)
Depowering Procedure
WARNING:
-
Always wear eye protection when servicing a vehicle. Failure to follow this instruction may result in serious personal injury.
-
Never probe the electrical connectors on air bag, safety canopy or side air curtain modules. Failure to follow this instruction may result in
the accidental deployment of these modules, which increases the risk of serious personal injury or death.
-
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious
personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Turn all vehicle accessories OFF.
2. Turn the ignition switch to OFF.
3. At the smart junction box (SJB), located below the LH side of the instrument panel, remove the cover and the RCM fuse 25 (7.5A) from the SJB.
4. Turn the ignition ON and visually monitor the air bag indicator for at least 30 seconds. The air bag warning indicator will remain lit continuously
(no flashing) if the correct RCM fuse has been removed. If the air bag warning indicator does not remain lit continuously, remove the correct RCM
fuse before proceeding.
5. Turn the ignition switch to OFF.
6. WARNING: Always deplete the backup power supply before repairing or installing any new front or side air bag supplemental restraint
system (SRS) component and before servicing, removing, installing, adjusting or striking components near the front or side impact
sensors or the restraints control module (RCM). Nearby components include doors, instrument panel, console, door latches, strikers, seats
and hood latches.
Refer to the Description and Operation portion of Air Bag Systems for location of the RCM and impact sensor(s).
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least 1 minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
Failure to follow these instructions may result in serious personal injury or death in the event of an accidental deployment.
Disconnect the battery ground cable and wait at least one minute.
Repowering Procedure
1. Turn the ignition switch from OFF to ON.
2. Install RCM fuse 25 (7.5A) to the SJB and close the cover.
3. WARNING: Make sure no one is in the vehicle and there is nothing blocking or placed in front of any air bag module when the battery is
connected. Failure to follow these instructions may result in serious personal injury in the event of an accidental deployment.
Connect the battery ground cable.
4. Prove out the SRS as follows:
