Milan FWD L4-2.3L (2008)
3. NOTE: The sensor and cradle must be positioned with the hinge side of the sensor on the RH side when viewed from the curb side (beauty side)
of the wheel.
NOTE: The sensor has raised markings indicating how to position the sensor.
Remove the adhesive tape liner from the cradle and position the sensor and cradle into the wheel drop well 180 degrees from the valve stem.
4. Install the tapered end of the strap through the opening of the cradle on the hinge side of the sensor. This will position the worm gear on the
locking clip side of the sensor.
5. CAUTION: Steel wheels have a "high spot" along their circumference. Make sure the strap and sensor are mounted at the lowest spot
possible to avoid damaging the sensor during wheel and tire disassembly and assembly.
NOTE: Keep the strap parallel with the wheel flange while tightening the worm gear.
Position the worm gear 13-26 mm (0.5-1.0 in) away from the sensor and tighten the worm gear.
^
Tighten to 3 Nm (27 lb-in).
