Milan FWD L4-2.3L (2008)
Backup Lamp Switch: Service and Repair
REVERSING LAMP SWITCH
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the fasteners and the lower engine splash shield.
3. NOTE: Discard the reversing lamp switch gasket.
Disconnect the electrical connector and remove the reversing lamp switch.
-
To install, tighten to 24 Nm (18 lb-ft).
4. To install, reverse the removal procedure.
-
Install a new reversing lamp switch gasket.
-
Check the transmission fluid and fill as necessary.
