Milan FWD L4-2.3L (2008)
Air Cleaner Housing: Service and Repair
AIR CLEANER
Exploded View
Removal and Installation
1. Disconnect the mass air flow (MAF) sensor electrical connector.
2. Loosen the clamp and disconnect the air cleaner outlet pipe from the air cleaner.
-
To install, tighten to 5 Nm (44 lb-in).
3. NOTE: No tools are needed to remove the air cleaner assembly. Removal should be carried out using hands only.
Separate the 3 air cleaner feet from the rubber grommets and the air cleaner inlet pipe and remove the air cleaner assembly.
4. NOTE:
-
Make sure that the 3 air cleaner feet are seated into the rubber grommets under the air cleaner assembly.
-
The air cleaner outlet pipe should be securely sealed to prevent unmetered air from entering the engine.
