Milan FWD L4-2.3L (2008)
NOTE:
-
Install new fuel injector O-ring seals and lubricate them with clean engine oil.
-
Make sure the fuel rail clips snap back into place.
Install the fuel injectors and the retainer clips into the fuel rail.
2. Install the fuel rail and fuel injectors as an assembly.
3. Install the 2 fuel rail bolts.
-
Tighten to 23 Nm (17 lb-ft).
4. Connect the 4 fuel injector electrical connectors.
5. Connect the 2 swirl control valve electrical connectors.
6. Install the fuel rail insulator and attach the 2 wiring harness retainers.
7. Connect the fuel tube quick connect coupling to the fuel rail.
8. Install the generator air inlet duct and the 2 nuts and the bolt.
-
Tighten to 6 Nm (53 lb-in).
9. Connect the battery ground cable.
