Milan FWD L4-2.3L (2008)
1. Remove the protective backing from the adhesive on the microphone and attach the microphone. (Figures 4 and 5)
^
Firmly press the microphone into place.
^ Ensure the microphone is parallel and adjacent to overhead console trim (if equipped), or positioned directly above A-pillar on headliner if not
equipped with an overhead console.
^
Proceed to Step 5 if not equipped with an overhead console.
2. Lower the overhead console. Refer to WSM, Section 417-02 for additional information.
3. Route microphone cable through existing hole in the headliner, and over to the passenger side A-pillar. It may be necessary to slightly drop headliner
to run microphone cable. Refer to WSM, Section 501-05 for additional information.
4. Install overhead console; ensure microphone cable enters the overhead console trim directly behind microphone as shown.
5. Gain access to connector 298 located behind the dash panel on passenger side. Refer to online WD, Section 124-1 for links to location and connector
views.
6. Identify circuits VMN07 (GY), RMN07 (VT), and DMN07 (shield - BK) from C298. Cut the three circuits on the male side of the connector
(17C712 harness).
7. Identify circuits CBP31 (BU-OG) and GD133 (BK) from C298 (2008 Navigator only). Identify circuits CBP41 (BU) and GD133 (BK) from C298
(2009 Expedition/Navigator only).
8. Splice the five jumper harness wires into the following circuits:
^
Blue jumper harness wire to CBP31 (BU-OG) and any black jumper harness wire to GD133 (BK) for 2008 Navigator only. Blue jumper harness
wire to CBP41 (BU) and any black jumper harness wire to GD133 (BK) for 2009 Expedition/Navigator only.
^
Ensure original circuits remain connected in splice.
