Milan FWD L4-2.3L (2008)
^
Yellow jumper harness wire to VMN07 (GY) and remaining black jumper harness wires to RMN07 (VT) and DMN07 (shield - BK).
^
Only splice into the cut wires heading in the direction of the connector. Tape off and secure the other cut wire ends as they are no longer used.
9. Connect the microphone connector to the jumper harness connector.
10. Bundle and tuck the remainder of the microphone cable above the headliner.
2008-2009 Explorer / Explorer Sport Trac / Mountaineer
1. Remove the protective backing from the adhesive on the microphone and attach the microphone. (Figure 6)
^
Firmly press the microphone into place.
^
Ensure the microphone is parallel and adjacent to overhead console trim.
2. Lower the overhead console. Refer to WSM, Section 417-02 for additional information.
3. Route microphone cable through existing hole in the headliner, and over to the driver side A-pillar. It may be necessary to slightly drop headliner run
microphone cable. Refer to WSM, Section 501-05 for additional information.
4. Install overhead console; ensure microphone cable enters the overhead console trim directly behind microphone as shown.
5. Gain access to connector 248 in the left A-pillar. Refer to online WD, Section 124-1 for links to location and connector views.
6. Identify and cut circuits VMNO7 (GY), RMNO7 (VT), and DMNO7 (shield) from C248. Cut the three circuits on the female side of the connector
(14334 harness).
7. Identify circuits CBP05 (YE) and GD143 (BK-VT) from C248.
8. Splice the five jumper harness wires into the following circuits:
^
Blue jumper harness wire to CBP05 (YE) and any black jumper harness wire to GD143 (BK-VT).
^
Ensure original circuits remain connected in splice.
^
Yellow jumper harness wire to VMN07 (GY) and remaining black jumper harness wires to RMN07 (VT) and DMN07 (shield).
^
Only splice into the cut wires heading in the direction of the connector. Tape off and secure the cut wire ends heading up the A-pillar as they are
no longer used.
9. Attach the microphone connector to the jumper harness connector.
10. Bundle and tuck the remainder of the microphone cable over the front of the headliner.
2009 F-150
