Milan FWD L4-2.3L (2008)
Failure to follow this instruction may result in the air bag deploying incorrectly, which increases the risk of serious personal injury or death in a
crash.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the SRS.
2. Open the glove compartment door and release the door damper cable, then fully lower the door.
3. Remove the 2 passenger air bag module bolts.
4. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment doors. Damage to the air bag module
may occur.
Through the glove compartment opening, release the deployment door clips from the instrument panel and then lift the passenger air bag module
out of the instrument panel.
5. NOTE: RH shown, LH similar.
Using a small screwdriver as shown, lift up and release the locking buttons on the 2 passenger air bag module electrical connectors.
6. CAUTION: Do not pull the passenger air bag module electrical connectors out by the locking buttons. Damage to the locking buttons can
occur.
NOTE: RH shown, LH similar.
With the locking buttons released, remove the 2 electrical connectors and the passenger air bag module.
