Milan FWD L4-2.3L (2008)
OCS rail shield is present, is not damaged and is correctly installed to the OCS rail. Failure to follow these instructions may result in incorrect
operation of the OCS system and increases the risk of serious personal injury or death in a crash.
NOTE: Make sure the OCS system rail shield is seated correctly on the OCS system rail. Align the locator pin to the shield and attach the OCS
system rail shield rear tab to the OCS system rail.
Position the OCS system rail shield on the OCS system rail. Then position the OCS system rail and shield on the seat track while noting the correct
installation of the OCS system rail locator pin into the seat track.
2. NOTE: To make sure of correct installation, the OCS system rail bolts must be installed in the sequence shown.
While holding the OCS system rail and shield firmly in position, install the OCS system rail front mounting position rear bolt.
-
Tighten to 25 Nm (18 lb-ft).
3. While still holding the OCS system rail and shield firmly in position, install the OCS system rail front mounting position front bolt.
-
Tighten to 25 Nm (18 lb-ft).
4. Move the seat to the forward most position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
