Milan FWD L4-2.3L (2008)
7. Disconnect the crankshaft position (CKP) sensor electrical connector.
8. Remove the bolts and discard the CKP sensor.
Installation
1. CAUTION: Only hand-tighten the bolt or damage to the front cover can occur.
Install a 6 mm (0.23 in) x 18 mm (0.7 in) standard bolt in the crankshaft pulley.
2. NOTE: Whenever the CKP sensor is removed, a new one must be installed using the alignment tool supplied with the new part.
Install the CKP sensor and the 2 bolts.
-
Do not tighten the bolts at this time.
