Location of Crankshaft Position Sensor on Milan FWD L4-23L (2008)
3. NOTE: The CKP sensor alignment tool is supplied with the new sensor and is not available separately.
Adjust the CKP sensor with the alignment tool.
-
Tighten the 2 CKP bolts to 7 Nm (62 lb-in).
4. Connect the CKP sensor electrical connector.
5. Remove the 6 mm (0.23 in) bolt from the crankshaft pulley.
6. Install the cylinder block plug.
-
Tighten to 20 Nm (15 lb-ft).
7. Install the 6 pin-type retainers (4 shown) and the RH splash shield.
8. Install the 4 screws and position the RH fender splash shield aside.
