Milan FWD L4-2.3L (2008)
Impact Sensor: Service and Repair
Side Impact Sensor - B-Pillar
SIDE IMPACT SENSOR - B-PILLAR
WARNING: Do not handle, move or change the original horizontal mounting position of the restraints control module (RCM) while the RCM
is connected and the ignition switch is ON. Failure to follow this instruction may result in the accidental deployment of the safety canopy and
cause serious personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
-
RH shown, LH similar.
-
Seat and carpet removed for clarity.
1. Depower the SRS.
2. Remove the front door scuff plate trim panel.
3. Remove the rear door scuff plate trim panel.
4. Remove the lower B-pillar trim panel.
-
Slide the lower B-pillar trim panel down to disengage it from the upper B-pillar trim panel.
5. Disconnect the side impact sensor electrical connector.
