Milan FWD L4-2.3L (2008)
Lower Arm
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
1. Remove the spring.
2. Remove the cam adjuster nut, cam adjuster, cam bolt and the lower arm.
^
Discard the nut.
^
To install, tighten to 101 Nm (74 lb-ft) with the suspension at the bushing fastener tightening position.
