Milan FWD L4-2.3L (2008)
^
Discard the bolts.
^
To install, tighten to 45 Nm (33 lb-ft) with the suspension at the bushing fastener tightening position.
6. Remove the stabilizer bar bracket nuts.
^
Discard the nuts.
^
To install, tighten to 40 Nm (30 lb-ft) with the suspension at the bushing fastener tightening position.
7. Remove the stabilizer bar bracket bolts and the brackets.
^
Discard the bolts.
^
To install, tighten to 40 Nm (30 lb-ft) with the suspension at the bushing fastener tightening position.
FWD vehicles
8. Remove the stabilizer bar.
AWD vehicles
9. CAUTION: Be careful not to contact the fuel lines or wiring harness when removing and installing the stabilizer bar or damage to the
wiring harness or fuel lines may occur.
Remove the stabilizer bar from the RH side of the vehicle.
All vehicles
10. Inspect the stabilizer bar bushings and install a new bushing(s) if necessary.
11. CAUTION: Before tightening any suspension bushing fasteners, the suspension must be at the bushing fastener tightening position. This
will prevent incorrect clamp load and bushing damage.
To install, reverse the removal procedure.
