Milan FWD L4-2.3L (2008)
6. CAUTION: Use care not to over stretch or extend the hose clamps.
CAUTION: The hose clamps are held on the hose with a special epoxy. Damage may occur to the hose if the clamp is removed from the
hose. If the clamp or hose is damaged, install a new fluid cooler tube.
Connect the transmission fluid cooler hoses to the transmission fluid cooler tubes.
7. Install the lower transmission fluid cooler tube in the radiator.
^
Tighten to 30 Nm (22 lb-ft).
8. Install the front splash shield.
1
Position the splash shield in place and install the 2 screws.
2
Install the fasteners.
3
Install the 4 bolts.
