Milan FWD L4-2.3L (2008)
^
Wear or rust on the splines
^
Install a new clutch disc if any of the these conditions are present.
8. Check the clutch disc runout.
9. If necessary, conduct a flywheel runout check.
10. Remove the clutch release bearing.
11. Inspect the clutch release bearing for wear or damage.
^
Rotate the bearing while applying pressure in the axial direction. If the bearing feels rough, sticks or has excessive resistance, install a new
bearing.
12. Inspect the release bearing guide tube for wear or damage.
^
Slide the release bearing on the guide tube. Check for roughness or sticking.
13. Remove the clutch release fork. Inspect the fork for wear or damage.
Installation
1. Apply a very small amount of grease in the clutch disc hub. Wipe off excess grease to avoid contaminating the clutch disc and affecting clutch
function.
2. Using a suitable clutch disc aligner, position the clutch disc on the flywheel.
