Milan FWD L4-2.3L (2008)
All Wheel Drive (AWD) Vehicles
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
Front wheel drive (FWD) vehicles
1. Remove the wheel and tire.
2. If equipped, remove the wheel speed sensor bolt and position the sensor aside.
3. Disconnect the parking brake cable from the brake caliper in the following sequence.
1
Remove the clip.
2
Disconnect the parking brake cable from the brake caliper.
4. CAUTION: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the anchor plate bolts and position the brake caliper and anchor plate assembly aside.
^
Support the brake caliper and anchor plate assembly using mechanic's wire.
5. Remove the 2 brake disc bolts and the brake disc.
6. Remove and discard the grease cap.
7. Remove and discard the wheel hub nut and remove the wheel hub and bearing assembly.
All wheel drive (AWD) vehicles
8. Remove the wheel knuckle.
9. Using the special tool, press the wheel hub from the wheel bearing.
