Milan FWD L4-2.3L (2008)
Transaxle Rear Support Insulator (Part 2)
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the 7 splash shield bolts and the splash shield.
^
To install, tighten to 47 Nm (35 lb-ft).
3. Remove the 2 lower transaxle rear support insulator bolts.
^
To install, tighten to 63 Nm (46 lb-ft).
4. Remove the battery.
5. Remove the battery tray.
1
Disconnect the positive battery cable retainer.
2
Remove the battery tray bolts.
^
Tighten to 9 Nm (80 lb-in).
