Milan FWD L4-2.3L (2008)
Heated Glass Element: Testing and Inspection
GRID WIRE TEST
1. Using a bright lamp in the vehicle, inspect the wire grid from the exterior. A broken grid wire will appear as a brown spot.
2. Run the engine at idle. Set the heated rear window switch to ON. The indicator light should come on.
3. Working in the vehicle with a voltmeter, contact the broad red-brown stripes of the rear glass window positive lead to battery side and the negative
lead to ground side. The meter should read 10-13 volts. A lower voltage reading indicates a loose ground connection.
4. Contact a good ground point with the negative lead of the meter. The voltage reading should not change.
5. With the negative lead of the meter grounded, touch each grid line of the heated rear window glass at its midpoint with the positive lead. A reading
of approximately 6 volts indicates the line is good. A reading of 0 volt indicates the line is broken between the midpoint and the B+ side of the
grid line. A reading of 12 volts indicates the circuit is broken between the midpoint of the grid line and ground.
6. Pinpointing the exact position of the break can be accomplished (if the voltmeter reads 0 volt when the midpoint of the grid line is touched with
the positive lead of the voltmeter) by moving the positive lead of the voltmeter toward the B+ side of the grid line and touching the grid line until
the voltmeter reads 6 volts. If the voltmeter reads 12 volts when the midpoint of the grid line is touched with the positive lead of the voltmeter,
simply move the positive lead of the voltmeter toward the ground connection of the grid line and touch the grid line until the voltmeter reads 6
volts.
