Milan FWD L4-2.3L VIN Z (2007)
Rear Bumper Reinforcement: Service and Repair
BUMPER - REAR
Removal and Installation
1. Remove the rear bumper cover.
2. Remove the rear bumper isolator from the rear bumper.
-
Pull the isolator rearward to remove it from the retaining pins.
3. Remove the 4 rear bumper nuts.
-
To install, tighten to 25 Nm (18 lb-ft).
4. Remove the 2 rear bumper bolts.
-
To install, tighten to 25 Nm (18 lb-ft).
5. Remove the rear bumper.
6. To install, reverse the removal procedure.
